Chilled Water Pump Vfd Control

A minimum of 3 differential pressure transducers will be connected to the ddc controllers of the chilled water system and these shall be used for pump speed control.

Chilled water pump vfd control.

The pumps are designed to operate in a parallel configuration. The purpose of the vfd installed on secondary chilled water pump motor is to increase or decrease the speed of motor in order to control increase or decrease water flow rate. Enable both primary and secondary chilled water pumps when outside air temperature is above setpoint and at least 1 chilled water coil control valve is open to coil. Vfd s variable frequency drives are usually employed to serve the purpose of feeding electrical power to pump motors as these provide a good control over speed of motor which in turn changes the gpm s gallon per minutes being supplied to load end.

Currently a single pump is operating in response to water flow requirements. This sends a signal to the chilled water control panel and vfds. It must first accurately monitor the system for changes in load dynamics. Based on the mathematical a model of pumps with or without variable frequency drives the paper discusses some issues in detail such as variable frequency drives configuration flow rate regulation and overload.

Before variable speed drive vsd and direct digital control ddc techniques existed the chilled water pump delivered the chilled water to distribution loops at the constant flow rate regardless of the variation of. This increase or decrese in motor speed and accodingly flow rate is governed by means of pressure sensors pressure transducers. This is an indication that the plant pressure is no longer sufficient to satisfy the building chilled water demand. Secondly it must respond to these load changes with the correct amount of flow run vfd s at constant speed balance then set pumps to auto 14.

The main goal of the secondary chilled water system is to distribute the correct amount of water to satisfy the load. A proper vfd retrofit of a chilled water plant should start with converting a constant volume cooling tower fan to variable volume since a varying cooling tower fan speed based on wet bulb and condenser water set points has no negative impacts on chiller performance. The control technology of vfd is closely related to characteristics of pumps. Enable chiller after flow is proven.

The secondary chilled water pump schwp sets will be controlled through vfd drives to maintain the desired system differential pressure. Calculated setpoint for more than 15 minutes adj close the bypass valve open the main building return control valve to 100 and enable the pump control sequence.